AWT Research Lab
Where the windings and the electronics are worked out
The lab is a bench, an oscilloscope, a signal generator and a lot of copper. We wind test coils, measure what the field around them actually does, and rebuild the electronics until a design is stable enough to make in series. Everything sold in the shop went through this bench first.
Open Measurements
We publish what we measure — frequency response, current draw, field strength at distance. Numbers, not adjectives.
Small Series
A design goes to production only after a working sample has run continuously for a month without drift.
Custom Builds
Need a different diameter, pitch or connector for your own setup? Send the spec and we will quote a one-off.
Practical applications
Device Development
From a winding sketch to a finished enclosure: choosing the wire, the pitch, the geometry, the power supply and the frequency control.
Bench Measurements
Oscilloscope, field tester, heat and current measurements. Every series has a measurement log we share on request.
Technical Documentation
Product data sheet, wiring diagram, electrical-safety requirements, user manual. The papers ship in the box with the device.